• Upgrade of the existing electrical cabinet (with relocation)
• Safety PLC (Complete system must fulfill safety level PLd )
• Upgrade of existing HMI
• Complete pull-wire system (approximately 6 new wires to be considered)
• Connection and signal exchange to equipment in the JEET line (18 control systems)
• Connection and signal exchange between E-stop cabinet and SCADA
• Install safe air exhausts (together with clean air filters) for releasing pressure in the system (1x pack area, 1x process area, 1x molding

Challenges of #Team RAP

“The greatest challenge was installing the new system and integrating it with the existing system without disrupting production continuity.“

Adrian Suciu – Project Manager

Project Insights

• This was made possible by preparing the connections in advance.
• For this, RAP Tronic Process Engineering sent a team a few weeks before the installation, and the moment of making the connections was chosen during one of the maintenance breaks of the existing line.
• Thus, in a record time, the existing line could be integrated into the new E-Stop system.